Garmin G1000 Pilot's Manual page 74

PRIMARY FLIGHT DISPLAY
NOTE: When adding an arrival to an active flight
plan, the pilot may need to remove a duplicate
destination waypoint from the flight plan list.
Figure 2-72 Select Arrival Window
Select Departure
Select Departure allows the pilot to choose a published
standard instrument departure (SID) for the departure
airport, or replace the current departure with a new
selection. When using a direct-to, the G1000 uses the
nearest airport as a reference when displaying available
departures.
To select a departure for the departure
airport:
1. From an active flight plan, press the PROC key
to display the Procedures options window.
Turn the large FMS knob to highlight 'Select
2.
Departure', then press the ENT key. A window
appears listing the available departures for the
departure airport.
Turn the FMS knob to select the desired depar-
3.
ture, then press the ENT key.
4. A window may appear listing runways for the
departure. Turn the FMS knob to select the
desired runway, then press the ENT key. The
transition window is now displayed.
2-44
5.
6.
Activate Approach
Activate Approach allows the pilot to activate the
approach when ready to begin navigating the approach
course (cleared for the approach).
To activate the approach for a direct-to or
flight plan destination airport:
1.
2.
Activate Vector-To-Final
Activate Vector-To-Final allows the pilot to activate the
final course segment of the approach. This option assumes
that the pilot will receive vectors to the final approach fix
(FAF) and provides guidance to intercept the final course,
before reaching the FAF.
To activate the approach with vectors to
final:
1.
2.
Garmin G1000 Pilot's Guide for Cessna Nav III
NOTE: The runway window is not displayed for
every departure. 'ALL' may appear in the runway
field, indicating that the departure procedure
applies to all runways. For airports with parallel
runways,'B' may appear at the end of the runway
designation to indicate that the departure
procedure applies to both runways.
Turn the FMS knob to select the desired transi-
tion, then press the ENT key.
With 'LOAD?' highlighted, press the ENT key.
From an active flight plan, press the PROC key
to display the Procedures options window.
Turn the large FMS knob to highlight 'Activate
Approach', then press the ENT key.
From an active flight plan, press the PROC key
to display the Procedures options window.
Turn the FMS knob to highlight 'Activate Vector-
To-Final', then press the ENT key.
190-00498-00 Rev. A