Garmin G1000 Pilot's Manual page 73

5. With 'LOAD?' highlighted, press the ENT key
to load the approach.
To activate the approach, turn the large FMS
6.
knob to highlight 'ACTIVATE?', then press the
ENT key.
NOTE: 'LOAD' adds the approach to the flight
plan without immediately using the approach
for navigation guidance. This allows the pilot to
continue navigating the original flight plan until
cleared for the approach, but keeps the approach
available for quick activation when needed.
'ACTIVATE' adds the approach to the flight plan
and begins navigating the approach course.
Select Arrival
Select Arrival allows the pilot to choose a published
standard terminal arrival route (STAR) for the destination
airport, or replace a current arrival with a new selection.
To select an arrival for a direct-to or flight
plan destination airport:
1. From an active flight plan, press the PROC key
to display the Procedures options window.
2. Turn the large FMS knob to highlight 'Select
Arrival', then press the ENT key. A window
appears listing the available arrivals for the
destination airport.
190-00498-00 Rev. A
Figure 2-69 Arrival
Garmin G1000 Pilot's Guide for Cessna Nav III
PRIMARY FLIGHT DISPLAY
3. Turn the FMS knob to select the desired arrival,
then press the ENT key. A window appears
listing the available transitions for the arrival.
Figure 2-70 Arrival Transition
Turn the FMS knob to select the desired transi-
4.
tion, then press the ENT key.
5. A window may appear listing runways for the
arrival. Turn the FMS knob to select the desired
runway, then press the ENT key.
NOTE: The runway window is not displayed for
every arrival. 'ALL' may appear in the runway
field, indicating that the arrival procedure
applies to all runways. For airports with parallel
runways,'B' may appear at the end of the runway
designation to indicate that the arrival procedure
applies to both runways.
Figure 2-71 Arrival Runway
6. With 'LOAD?' highlighted, press the ENT key.
2-43