Garmin G1000 Pilot's Manual page 69

Figure 2-60 Departure Runway
NOTE: The runway window is not displayed for
every departure. 'ALL' may appear in the runway
field, indicating that the departure procedure
applies to all runways. For airports with parallel
runways,'B' may appear at the end of the runway
designation to indicate that the departure
procedure applies to both runways.
Turn the FMS knob to select the desired transi-
5.
tion waypoint, then press the ENT key.
Figure 2-61 Departure Transition
With 'LOAD?' highlighted, press the ENT key.
6.
Figure 2-62 Select Departure Window
190-00498-00 Rev. A
Load Arrival
Load Arrival allows the pilot to select a published
standard terminal arrival route (STAR) for the destination
airport or replace a current arrival with a new selection.
To select an arrival for a direct-to or flight
plan destination airport:
1.
2.
3.
4.
5.
6.
Garmin G1000 Pilot's Guide for Cessna Nav III
PRIMARY FLIGHT DISPLAY
NOTE The PROC key can also be used to load a
:
departure, an approach, or an arrival.
NOTE: When adding an arrival to an active flight
plan, the pilot may need to remove a duplicate
destination waypoint from the flight plan list.
From the Flight Plan Window, press the MENU
key to display the page menu options.
Turn the FMS knob to highlight 'Load Arrival',
then press the ENT key. A window appears
listing the available arrivals for the destination
airport.
Turn the FMS knob to select the desired arrival,
then press the ENT key. A window appears
listing available transitions for the arrival.
Turn the FMS knob to select the desired transi-
tion waypoint, then press the ENT key.
A window may appear listing runways for the
arrival. Turn the FMS knob to select the desired
runway, then press the ENT key.
NOTE: The runway window is not displayed for
every arrival. 'ALL' may appear in the runway
field, indicating that the arrival procedure
applies to all runways. For airports with parallel
runways,'B' may appear at the end of the runway
designation to indicate that the arrival procedure
applies to both runways.
With 'LOAD?' highlighted, press the ENT key.
2-39