Cross-Connecting Telephones - Nortel Meridian 1 Manual

Page 52 of 144 Telephones

Cross-connecting telephones

553-3001-215 Standard 12.00 January 2002
Be sure to connect the telephones according to Figures 14 or 15. Figure 14 on
page 53 provides the diagram for cross-connecting analog (500/2500-type)
telephones on a peripheral equipment (PE) module. Tables 11, 12, and 13
show analog (500/2500-type) telephone cross-connections on an Intelligent
Peripheral Equipment (IPE) module.
Cross-connections for the M2000 Series Meridian Digital Telephone are
shown in Figure 15 on page 58.
Procedure 10
Cross-connecting telephones
1 Locate the telephone terminations at the cross-connect terminal.
Telephone terminations are located on the vertical side of the frame
when frame-mounted blocks are used and in the blue field when
wall-mounted blocks are used.
2 Connect Z-type cross-connecting wire to the leads of the telephone.
See Table 14 on page 57 and on page 57.
3 Locate the line circuit card (TN) terminations.
Line circuit card (TN) terminations are located on the horizontal side of
the distributing frame when frame-mounted blocks are used and in the
white field when wall-mounted blocks are used.
4 Run and connect the other end of the cross-connecting wire to the
assigned TN terminal block.