Nortel Meridian 1 Manual page 33

5 Remove the line circuit card if required. Refer to Circuit Card:
Installation and Testing (553-3001-211).
Procedure 3
Installing M2000 Series Meridian Digital Telephones
(M2006/M2008/M2008HF/M2016S/M2616/M2216ACD)
1 Complete the wiring and cross-connections (loop power) before
connecting the telephone to the connecting block. See Figure 10 on
page 30 and Figure 11 on page 31.
2 Place the telephone upside down on a number of sheets of soft, clean
paper on a solid, level work surface to prevent damage to movable
keys and the telephone's face.
3 Connect the handset cord (5-conductor TELADAPT connectors) to the
handset and snap it into place (not applicable to M2216ACD).
4 Connect the other end of the handset cord to the connector in the
bottom cover of the telephone. Turn the smooth side of the handset
cord up (away from the telephone bottom cover) before tucking it under
the restraining tab to ensure that the telephone will sit level on the desk
after installation is complete (not applicable to M2216ACD).
5 Connect the line cord to the telephone bottom cover. Route the cord
through the channels.
6 Turn the telephone right side up and place it in the normal operating
position.
7 Print the directory number on the designation card. Using a paper clip,
remove the number lens from the telephone. Insert the designation
card and snap the lens back into place.
8 Designate the feature keys.
9 Insert the line cord TELADAPT connector into the connecting block
and snap it into place.
10 Perform the self-test (see Procedure 1) and acceptance test
procedures. See LD 31 in the Software Input/Output Guide
Administration (553-3001-311).
11 Supply the user with a quick reference card and all user
documentation. Make sure the SPRE number is printed on the quick
reference card.
Telephones
Telephone and Attendant Console Installation
Page 29 of 144