Nortel Meridian 1 Manual page 86

Page 82 of 144 Add-on modules
Table 19:
Flexible Voice and Data feature configuration
Prompt Response
REQ: NEW/CHG
TYPE: aaaa
TN Iscu
CLS FLXA
VCE
KEY
-Key xxSCRyyyy
xxSCNyyyy
553-3001-215 Standard 12.00 January 2002
Procedure 1
Installing and removing the Analog Terminal Adapter
CAUTION WITH ESDS DEVICES
Before handling internal telephone components,
discharge static electricity from hands and tools by
touching any grounded metal surface or conductor.
1 When the ATA is installed, the System Administrator must activate the
Flexible Voice and Data Feature by configuring LD 11.
2 To Activate the Flexible Voice and Data Feature, use the following
chart to configure LD 11 (for more detailed information, refer to
Software Input/Output Guide Administration (553-3001-311)).
New, or change
Telephone type, whereaaaa=2006,2008, 2016, or 2616
Terminal Number where u=16-31
Flexible voice/data allowed. This Class of service can only be
assigned to 2006, 2008, 2016, 2216 or 2617 sets. When configured
to CLS=FLXA
(FLXD) = Flexible voice/data denied. Voice Class of Service (VCE)
can be assigned to the upper TN unit (16-31) and Data class of
Service (DTA) can be assigned to the lower TN (0-15). A Single Call
Ringing (SCR) key can be designated a Data Mode (DTNK) key.
Prime Directory Number Key, SCR, SCN, MCR or MCN and xxx.
Single Call Ringing
Single Call Non Ringing Data Mode Key, where xx=key number and
yyy=Data Directory Number.
3 Disconnect and remove all cords (including the handset cord) from the
telephone.
Description