Nortel Meridian 1 Manual page 88

Page 84 of 144 Add-on modules
553-3001-215 Standard 12.00 January 2002
10 If the phone is equipped with a Power Option board and/or cable, you
must remove it before installing the ATA. The Power Option board is
located on the left side of the telephone:
• Remove the two small screws from the Power Option board
(near the top) and set them aside.
• To disconnect the Power Option board from the NTZK
telephone, grasp the board firmly on each side and slowly rock
the Power Option board while applying upward pressure until it
is released form the 2X7 pin connector.
• To disconnect the NT2K Power Option board from the set
simply remove the screws from the Power Option board and
base and lift the board out of the set.
• If the Power Option board has a ribbon cable, disconnect the
cable from the 2X7pin connector on the main board and
remove the cable