Nortel Meridian 1 Manual page 108

Page 104 of 144
Installing Displays
553-3001-215 Standard 12.00 January 2002
Add-on modules
14 Replace the base.
15 Insert all screws and tighten them.
16 If the telephone has an MCA or MPDA, plug its cable into the jack on
the telephone base.
17 Install the footstand, and secure it with two screws.
18 Reconnect all cords, including the handset.
Note: Place the label supplied with the power supply board on the
outside of the bottom cover of the telephone. This allows proper
identification and tracking of the option level of the set.
The following procedures cover installation of the various displays on the
various sets.
• Installing NT2K24WA or NT2K25YL displays on NTZK sets:
— M2008 – Use Procedure 1 on page 105.
— M2616 or M2216ACD – Use Procedure 1 on page 108.
• Installing NT2K28AA displays on NTZK or NT2K sets:
— Use Procedure 1 on page 111.
• Installing NT2K24WA or NT2K25YL displays on NT2K sets:
— M2008 – Use Procedure 1 on page 116.