Nortel Meridian 1 Manual page 15

7 Enter the related attendant console data in the Meridian 1 system.
Refer to the Software Input/Output Guide Administration
(553-3001-311).
8 Test the console features using the attendant console user guide.
Note: Refer to Circuit Card: Installation and Testing (553-3001-211)
for circuit card installation procedures.
Procedure 3
Removing the M2250 attendant console
1 Remove related attendant console data from the system memory.
Refer to the Software Input/Output Guide Administration
(553-3001-311).
2 Locate and remove cross-connections from the attendant console
cable at the cross-connect terminal. See Procedure 1 on page 18.
3 Remove the circuit card if required. Refer to Circuit Card: Installation
and Testing (553-3001-211).
Note: Do not remove the circuit card if any of the remaining units on
the card are assigned.
4 Disconnect the Amphenol connector on the end of the cable that leads
to the cross-connect terminal from the connector on the cable leading
to the attendant console.
5 Pack the attendant console, handset, and cords in a suitable
container.
Procedure 1
Removing theM2250 attendant console top cover
1 Disconnect any plugs and cords from the attendant console.
2 Remove the ten 10-mm fastening screws in the flange of the attendant
console, as well as one 10-mm and one 40-mm screw on the base of
the attendant console. See Figure 4 on page 12 for the M2250
assembly drawing.
3 Holding the top cover and the base together by hand, turn the
attendant console right-side up and place it back on the work surface.
Attendant console
Telephone and Attendant Console Installation
Page 11 of 144