Nortel Meridian 1 Manual page 99

Figure 31
M2006/M2008 telephone and option boards
H1
connector
P1
connector
R
5
Slot
B
Slot
A
J1
connector
J2
connector
12 Replace the base. If the telephone is equipped with an MPDA or MCA,
reconnect the data cable to the base telephone jack and replace the
footstand (ensuring that the MPDA or MCA cable does not get pinched
between the base and footstand). Make sure the footstand is firmly
seated to the base.
Note: Place the label supplied with the power supply board on the
outside of the bottom cover of the telephone. This allows proper
identification and tracking of the option level of the set.
13 Tighten all screws, reconnect the line cord, and place the telephone in
the normal operating position.
Power
board
Add-on modules
Alerter
board
Display
board
Telephone and Attendant Console Installation
Page 95 of 144
P3
connector
P2
connector
H1
connector
553-
1847