Packing And Unpacking; Installation And Removal - Nortel Meridian 1 Manual

Page 28 of 144 Telephones

Packing and unpacking

Installation and removal

553-3001-215 Standard 12.00 January 2002
Use proper care while unpacking any digital telephone. Check for damaged
containers so that appropriate claims can be made to the transport company
for items damaged in transit.
If a telephone must be returned to the factory, pack it in the appropriate
container to avoid damage during transit. Remember to include all loose parts
(cords, handset, power unit, labels, and lenses) in the shipment.
Do not remove the circuit card if any remaining units on the card are assigned.
Procedure 1
Installing 500/2500 telephones
1 Ensure that the wiring is installed at the telephone's location.
2 Unpack and inspect the telephone for damage. Assemble the handset
and line cords if necessary.
3 Install the required designations on the telephone.
4 Connect the telephone to the connecting block or connector.
5 Cross-connect the telephone wiring at the cross-connect terminal.
6 Configure the telephone in the system. Refer to the Software
Input/Output Guide Administration (553-3001-311).
Procedure 2
Removing 500/2500 telephones
1 Remove telephone data from the system. Refer to the Software
Input/Output Guide Administration (553-3001-311).
2 Disconnect the telephone from the connecting block or connector.
3 Pack the telephone in a container.
4 If necessary, remove the cross-connections for the telephone at the
cross-connect terminal.