Nortel Meridian 1 Manual page 123

16 Replace the base. If the telephone is equipped with an MPDA or MCA,
reconnect the data cable to the base telephone jack and replace the
footstand (ensuring that the MPDA or MCA cable does not get pinched
between the base and footstand). Make sure the footstand is firmly
seated to the base.
Note: Place the label supplied with the display on the outside of the
bottom cover of the telephone. This allows proper identification and
tracking of the option level of the set.
17 Tighten all the screws, reconnect all cords, and place the telephone in
the normal operating position.
18 Perform the self-test (Procedure 1) and acceptance test procedures.
See LD 31 in the Software Input/Output Guide Administration
(553-3001-311).
Procedure 1
Installing and removing the M2616 Display on NT2K sets
CAUTION WITH ESDS DEVICES
Before handling internal components of telephones,
discharge static electricity from hands and tools by
touching any grounded metal surface or conductor.
1 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to movable keys and the telephone face.
2 Disconnect all cords from the telephone.
3 Remove the two screws from the footstand assembly and unsnap the
footstand assembly by pressing inward at the back of the footstand
where it meets the base and pulling upward.
4 If the telephone is equipped with an MPDA or MCA, unplug the data
cable from the base telephone jack. Remove the five screws securing
the base to the telephone. Remove the base and set it aside.
5 If the telephone is not equipped with a display, go to step 9. If the
telephone is equipped with a display, go to step 6.
Add-on modules
Telephone and Attendant Console Installation
Page 119 of 144