Nortel Meridian 1 Manual page 77

4 Remove the 12 fastening screws in the base of the attendant console
that secure the top cover to the console base (see Figure 18 on
page 64). Holding the console base and cover firmly, turn it back over
so that the top cover is on, facing up.
5 Raise and hold the top cover to remove the single cable connector.
The alerter cable does not need to be removed (see Figure 19 on
page 65). Remove the top cover and place it upside down to the left of
the attendant console.
6 The attendant console's main PCB has holes located in the upper
right-hand side, near grid positions D1, D5, and A5. See Figure 25 on
page 74. Insert one standoff in each of the holes, twisting it until it is
secure.
CAUTION
Damage to Equipment
Once a standoff is inserted, it cannot be removed. Be
sure to place each standoff in the correct hole on the
main PCB, as shown in Figure 25 on page 74.
7 Position the ASM board over the J3 connector on the console's main
PCB. Align the holes on the ASM board with the standoffs and carefully
work the ASM pin connector onto connector J3 until firmly seated. See
Figure 25 on page 74.
8 Hold the top cover over the attendant console and reconnect the cable
connector onto the base of the console.
9 Place the top cover on the console. Slide it back and down into place.
Check that all the cables are in the correct positions, and that none are
trapped.
10 Ensure that the volume switch is fully engaged in the correct slider.
Hold the top cover and console base firmly together. Turn the
assembly upside down.
11 Reinsert the 12 screws that secure the top cover to the console base
and tighten.
12 If required, replace the adjustable stand.
13 Reconnect the main system cable to the rear of the console.
Add-on modules
Telephone and Attendant Console Installation
Page 73 of 144