Nortel Meridian 1 Manual page 122

Page 118 of 144
Figure 41
Connecting the cable to the display board
553-3001-215 Standard 12.00 January 2002
Add-on modules
15 Fold the ribbon cable near the connector to align with the J2 pins on
the display board, ensuring that the notch on the ribbon cable is facing
toward the display board. Carefully work the ribbon cable connector
onto the J2 pins until it is firmly seated. Route the cable flat beside the
power supply board, gathering excess cable under the display. Be
careful not to press the cable beneath the alignment posts or studs of
the base. See Figure 41 on page 118.
553-6325