Nortel Meridian 1 Manual page 119

17 Slide the ribbon cable connector onto the connector pins (P2 on an
NTZK M2008, J3 on an NT2K M2008, and P4 on an M2616) on the
mother board.
CAUTION
This connection is polarity sensitive.
18 Ensure that the pins line up with the connector correctly and carefully
work the connector on until it is firmly seated.
Reattaching the Base
19 Make sure the ribbon cable is lying flat and not caught over or under
any alignment posts or studs on the telephone base. (For the M2616,
allow it to cover the screwpost and do not replace the screw on
re-assembly.)
20 Replace the base.
21 Insert all screws (except the center screw on the M2616) and tighten
them.
Reattaching the Footstand
22 If the telephone has a Meridian Programmable Data Adapter (MPDA)
or Meridian Communications Adapter (MCA), plug its cable into the
jack on the telephone base.
23 Replace the footstand, positioning it firmly on the base.
24 Insert and tighten all screws.
Note: Place the label supplied with the display on the outside of the
bottom cover of the telephone. This allows proper identification and
tracking of the option level of the set.
Reconnecting the Telephone
25 Reconnect all cords.
26 Turn the telephone right-side-up and place it in a normal operating
position.
Add-on modules
Telephone and Attendant Console Installation
Page 115 of 144