Nortel Meridian 1 Manual page 68

Page 64 of 144 Add-on modules
Figure 18
Removing the fastening screws
553-3001-215 Standard 12.00 January 2002
Remove These
12 Screws
Do Not Remove
These Screws
6 Remove the top cover and place it upside down to the left of the
attendant console.
7 Remove the knockout section on the back of the attendant console
(see Figure 20 on page 66) with a small screwdriver or similar tool.
Remove any remnants of the breakaway tags.
8 Feed the flat ribbon cable for the Busy Lamp Field/Console Graphics
Module (BLF/CGM) through the knockout hole in the base of the
attendant console.
9 Hold the BLF/CGM unit over the console in a vertical position, ensuring
that the two locators on the bottom bracket of the BLF/CGM are
located in the knockout hole.
10 Push down on the attendant console, while holding the BLF/CGM unit,
until the two locators snap into place. See Figure 21 on page 67.
Do Not Remove
These Screws
Polystyrene
Foam Sheet
553-1890