Designating Attendant Consoles - Nortel Meridian 1 Manual

Page 14 of 144 Attendant console

Designating attendant consoles

553-3001-215 Standard 12.00 January 2002
5 Select the Data Port option from the Diagnostics menu by dialing "3".
The LCD screen displays OK when the test is successfully completed.
If there is a hardware fault on the M2250, A0H is displayed.
If the blank RS-232 connector is not plugged into the data port
correctly (Step 4), the display reads 90H or A0H.
6 Press the Asterisk (*) key to repeat the test.
7 To exit the test mode press the octothorpe (#). This returns you to the
main Diagnostics menu.
8 Press the octothorpe to return to normal operating mode.
9 Remove the loopback connector from the Data Port RS-232 jack.
Refer to the work order to determine the features and key designations for
each attendant console. Designate each key on the attendant console by
placing its feature name (from the designation sheet) in the key cap that fits
on the key.
The Directory Number (DN) designation window on the M2250 attendant
console is located above the keypad.
Procedure 4
Designating attendant consoles
1 Remove the cap from each key requiring a designation by gently
pulling upward on the cap.
2 Remove the appropriate designation from the sheet of designations.
3 Place the designation in the cap, place the cap over the corresponding
key, and gently press down. Repeat this procedure for all keys
requiring designations.
4 Insert a paper clip in the hole at the left or right end of the DN
designation window. Pry the window open.
5 Insert the number tag, and replace the designation window.