Nortel Meridian 1 Manual page 110

Page 106 of 144
Figure 36
Display cable routing
553-3001-215 Standard 12.00 January 2002
Add-on modules
Removing the display
8 Remove the two or three screws from the display module. Remove the
display from the telephone. To install the display option, go to step 11.
Installing the display board
9 Place the J1 connector of the display board over the P2 pins of the
telephone. See Figure 37 on page 110. Press down slowly until J1
slides onto the P2 pins and is firmly seated.
Set
10 Insert the self-tapping Phillips-head screw supplied with the display
into the mounting hole (near the top). Tighten it firmly with a #1 Phillips
screwdriver.
Display
Module
Display
Board
excess
cable
P4 pin
connector
mounting
hole
J1
connector ribbon
cable (fold)
J2 pin
connector
553-2046