Nortel Meridian 1 Manual page 95

Figure 30
Installing the MCA
8 If the phone is equipped with the External Alerter board, it must be
removed before installing the MCA with redesigned footstand.
• The External Alerter board is located at the right center of the
telephone.
• Remove the screws form the board, grasp the board firmly on
each end and pull upward to remove it from the 2X3 pin
connector.
9 Install the Jumper board onto the 2X7 pin connector inside the phone
base.
• If the phone set did not have a Power Option board installed on
the NT2K or the NTZK then there will be 2 Jumper plugs on the
2X7 connector. Remove them before installing the Jumper
board.
• The redesigned footstand will have 2 jumpers. Use the black
one for the NT2K phone and the brown one for the NTZK
phone.
10 Remove the large MCA knockout section in the rear of the telephone
footstand assembly, and remove the small tabs. See Figure 30. It is
best to remove this knockout with a screwdriver.
Add-on modules
2
1
Telephone and Attendant Console Installation
Page 91 of 144
MCA
Board
553-6328