Nortel Meridian 1 Manual page 102

Page 98 of 144 Add-on modules
553-3001-215 Standard 12.00 January 2002
10 Take the self-tapping Phillips-head screws supplied with the power
supply board and install them into the mounting holes. Tighten firmly
with a #1 Phillips screwdriver.
11 If the telephone has a display, reconnect the display ribbon cable,
routing the cable as described in Procedure 1 on page 108.
Note: Do not allow R5 on the power supply board to become bent
during this procedure.
12 Replace the base. If the telephone is equipped with an MPDA or MCA,
reconnect the data cable to the base telephone jack and replace the
footstand (ensuring the MPDA or MCA cable does not get pinched
between the base and footstand). Make sure the footstand is firmly
seated to the base.
Note: Place the label supplied with the power supply board on the
outside of the bottom cover of the telephone. This allows proper
identification and tracking of the option level of the set.
13 Connect the telephone to a local transformer (see Figure 33 on
page 99) or closet power supply (see Figure 34 on page 100). Refer to
Meridian 1 Telephones: Description and Specifications
(553-3001-108) for requirements.