Nortel Meridian 1 Manual page 109

Installing NT2K24WA or NT2K25YL displays on NTZK sets
To install the display on an M2008 set, use Procedure 1. To install the display
on an M2616 or M2216ACD set, use Procedure 1 on page 108.
Procedure 1
Installing and removing the M2008 Display on NTZK sets
1 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to movable keys and the telephone face.
2 Disconnect all cords from the telephone.
3 Remove the two screws from the footstand assembly and unsnap the
footstand assembly by pressing inward at the back of the footstand
where it meets the base and pulling upward.
4 If the telephone is equipped with an MPDA or MCA, unplug the data
cable from the base telephone jack. Remove the four screws securing
the base to the telephone. Remove the base and set it aside.
5 The power supply board (if equipped) is located on the left side of the
telephone. Remove the two small screws from the power supply board
(near the top) and set aside. Grasp the board firmly on each side.
Carefully work the board loose until it is released.
6 If the telephone is not equipped with a display, go to step 9. If the
telephone is equipped with a display, go to step 7.
Removing the display board
7 The display board is located at the left center of the telephone.
Disconnect the display ribbon cable from the display board. Remove
the small screw from the board. Grasp the board firmly on each end
and pull upward to remove. To replace, go to step 9.
CAUTION WITH ESDS DEVICES
Before handling internal components of telephones,
discharge static electricity from hands and tools by
touching any grounded metal surface or conductor.
Telephone and Attendant Console Installation
Add-on modules Page 105 of 144