Nortel Meridian 1 Manual page 87

4 Place the telephone, face-down, on a padded level surface.
5 Using a #1 Phillips screw driver, remove both screws and separate the
footstand from the phone base.
6 If using the NT9K ATA ready set or the NT2K with date code of April
24, 1998 or later:
• Remove and retain the footstand (this footstand will be
reattached back onto the set base after ATA installation is
complete.
• Skip to the ATA Installation Procedure 13 on page 86.
7 If using the NT2K or the NTZK phone set, remove and discard the
footstand. Use the redesigned footstand required for the installation of
the ATA.
8 If an MCA or MPDA installed is installed, unplug it from the data line
jack in the phone base.
9 Remove the back covering of the phone base by removing the four
screws.
Figure 28
Telephone base and footstand
Add-on modules
Telephone and Attendant Console Installation
Page 83 of 144
Footstand