Nortel Meridian 1 Manual page 112

Page 108 of 144
553-3001-215 Standard 12.00 January 2002
Add-on modules
Procedure 1
Installing and removing the M2616/M2216ACD Display on NTZK sets
CAUTION WITH ESDS DEVICES
Before handling internal components of telephones,
discharge static electricity from hands and tools by
touching any grounded metal surface or conductor.
1 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to movable keys and the telephone face.
2 Disconnect all cords from the telephone.
3 Remove the two screws from the footstand assembly and unsnap the
footstand assembly by pressing inward at the back of the footstand
where it meets the base and pulling upward.
4 If the telephone is equipped with an MPDA or MCA, unplug the data
cable from the base telephone jack. Remove the five screws securing
the base to the telephone. Remove the base and set it aside.
5 If the telephone is not equipped with a display, go to step 9. If the
telephone is equipped with a display, go to step 6.
Removing the display board
6 The display board is located at the left center of the telephone.
Disconnect the display ribbon cable from the display board. Remove
the small mounting screw from the board. Grasp the board firmly on
each end and pull upward to remove it. To replace it, go to step 9.
Removing the display
7 The power supply board is located on the left side of the telephone.
Remove the two small screws from the power supply board (near the
top) and set them aside. Grasp the board firmly on each side. Carefully
work the board loose until released.
8 Remove the two or three screws from the display Module. Remove the
display from the telephone. To install the display, go to step 11.