Designating Telephones - Nortel Meridian 1 Manual

Designating telephones

Before designating telephones, check the work order for features enabled and
key designations. Designate each key by placing its feature name (from the
designation sheet) in the key cap that fits on the key.
Follow the steps in Procedure 5 to designate 500-type telephones:
Procedure 5
Designating 500-type telephones
1 Remove the finger wheel and number card from its envelope.
2 Designate the number card with the appropriate directory number and
station designator.
3 Insert the number card into the finger wheel (making sure the number
card is properly oriented).
4 Place the telephone on a flat surface.
5 Place the finger wheel over the clamp on the dial, with the "0" hole
directly over the digit "9," making sure the finger wheel depressions are
properly positioned on the prongs of the clamp plate.
6 Rotate the finger wheel counterclockwise until the clamp spring snaps
into the notch on the underside of the finger wheel.
Follow the steps in Procedure 6 to remove the finger wheel from 500-type
telephones.
Procedure 6
Removing the finger wheel from 500-type telephones
1 Place the telephone on a flat surface.
2 Rotate the finger wheel clockwise as far as possible.
3 Insert a paper clip into the small hole between the digits "9" and "0"
located on the edge of the grooved section of the finger wheel.
4 Press down on the releaser to disengage the finger wheel clamp
spring.
5 Rotate the finger wheel further clockwise until the clamp spring
releases.
Telephones
Telephone and Attendant Console Installation
Page 49 of 144