Table of Contents
Advertisement
5-1. Notes during Installation
w
Safety installation
Two or more people must install the equipment, at least one of whom must be trained.
Storage of parts
Store the outside cabinets removed during installation in a safe place to avoid damage.
Also store the removed parts and the unpacked parts that are supplied with the series consoles as well as
the outside cabinets.
n
Many outside cabinets need to be removed during installation. It is convenient to put marks or stick
memos on the portions to indicate where the outside cabinets should be reattached.
Installation procedure
The parts such as guide rails have been attached on the floor inside of the console in order to ensure
precision. Do not damage the parts by stepping on them or dropping tools. In addition, be careful not to
transform or damage the other parts inside the console.
Depth of the set during load
The depth of the set including the table top is 1100 mm. It is 800 mm or less when the outside cabinets
are not attached.
The outside cabinets required to be removed are as follows.
1 Table top
2 Drive stage panel + stage panel support
3 Drive stage, front top plate, front base plate, side panels (FL/FR)
Depth when 1 is not attached :
Depth when 1 and 2 are not attached :
Depth when 1, 2 and 3 are not attached : 800 mm or less
For more details of removal, refer to Section 6-2, "Removal and Installation of the Cabinets".
Screws
. Be careful not to forget to fasten the screws during installation. Put unnecessary screws away and do
not leave the screws unfastened. If any part or screw falls during operation, a failure or malfunction
may occur.
. When fastening the screws, use the following tightening torque.
Hexagonal head cap bolt (M3) : 1.4 N.m (14 kgf.cm)
Hexagonal head cap bolt (M4) : 2.5 N.m (25 kgf.cm)
Hexagonal head cap bolt (M5) : 3.5 N.m (35 kgf.cm)
Phillips screw (M3) :
Phillips screw (M4) :
Power supply
. Before removing the cabinets, be sure to confirm that the power of the console is turned off.
. For more details of turning on and off the power, refer to the supplied Operation Manual.
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
Section 5
About Installation Work
975 mm
900 mm or less
0.8 N.m (8 kgf.cm)
1.4 N.m (14 kgf.cm)
5-1
Advertisement
Table of Contents
