Table of Contents
Advertisement
(3) Attach the supplied EX stage supports UL/UR with the
six screws (PWH4 x 8).
PWH4 x 8
PWH
4 x 8
EX stage support (UR)
PWH4 x 8
PWH
4 x 8
EX stage support (UL)
(4) Remove the drive stage panel while referring to
Section 6-5.
(5) Remove the reinforcement angle from the top drive
stage.
Reinforcement
angle
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
(6) Attach the four screws and reinforcement angle that
(7) Connect the wires of the sensor to the connector (CN3)
PSW4 x 8
(8) Install the drive while referring to steps 2 through 7 of
were removed in step 4 to the bin side as shown in the
figure.
PSW4 x 8
Reinforcement
angle
PSW4 x 8
on the CB-110 board through the locking adjust
clamps.
Harness of the sensor
CN3
CB-110
board
Locking adjust
clamps
"2. Installing in the bottom stage of the drive stage".
6-9. Installation of the Tape Drive
Locking adjust
clamps
6-53
Advertisement
Table of Contents
