Table of Contents
Advertisement
Fixing the Console
(In case of 3 to 6 extension consoles)
1. Check that height of the point A is 110 mm above the
floor.
If height of the point A is not 110 mm above the
floor, adjust the height by loosening the four nuts of
the respective casters with hexagon allen wrench
(diagonal size 10 mm) and by adjusting the casters.
(Rotating a caster 360 degrees clockwise raises the
console by 2.5 mm. Rotating a caster 360 degrees
counter-clockwise lowers the console by 2.5 mm.)
2. Place a level on the portions B and C, and check that
the basic console is level. If they are not level, adjust
them by adjusting the casters until they are level.
Allen wrench
(10 mm)
M20
N20
Caster
Height from the floor level is 110 mm.
The bubble in the level must stay in the
center of the internal gauge lines.
3. Loosen the four nuts securing the floor levelers.
4. Rotate the hexagonal bolt block of the floor leveler by
hand until the feet of the console contacts the floor,
and completely ground them on the floor.
n
If the bolt block cannot be rotate by hand, use a spanner.
In addition, be careful not to rotate the bolt block exces-
sively. Otherwise, the console will be raised.
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
A
B
Bubble
5. Respectively rotate the four floor levelers by 180d with
a spanner.
6. Fasten the nut.
(Use a spanner of 30 mm across.)
Nut
C
Hexagonal bolt
block
Floor leveler
6-4. Installation of the Basic Console
6-11
Advertisement
Table of Contents
