Sony PetaSite DMS-B150L Installation Manual page 61

n
Fix the cable carefully so that the cable must not contact
with the synchro shaft or frame's side panel.
. Synchro shaft side :
. Frame side panel's side : The cable must be positioned
Synchro shaft
X cable bracket
Y rail
Y harness bracket (1)
7. Check tha the cables are not overlapped inside the
runner flex.
8. Move the runner flex near the end of the second
extension console. Then push the four cables out to the
drive stage side from the hole of the guide channel (3)
assembly.
9. Fix the metal plate of the runner flex with the two
screws (PWH 4 x 12).
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
The cable must be positioned
closer to the Y rail side than the
end surface A of the X cable
bracket (EXD).
within 40 mm from the Y
harness bracket (1).
A
Frame side panel
40 mm
Runner flex
PWH4 x 12
Hole of the guide channel
(3) assembly.
10. Connect the five connectors of the cable to the mating
connector of the cable relay plate (EXD).
Cable relay plate (EXD)
Connectors
11. Fix the cable with the locking adjust clamp so that the
cable must not move to near the runner flex side than
A and B.
Locking adjust clamps
Cable relay plate
A
(EXD)
6-6. Installation of DMSA-CBL1
Runner flex
Guide channel (3)
assembly
B
6-35