Sony PetaSite DMS-B150L Installation Manual page 62

6-6. Installation of DMSA-CBL1
12. Route the top of the SV cable cover (EXD2) through
the four screws of the guide channel (3) assembly and
fix it with the two screws (PWH4 x 8) to the metal
plate of the runner flex.
SV cable cover
(EXD2)
PWH
4 x 8
SV cable cover (EXD2)
Screws
6-36
5. Installing the Idler Assembly
Install the idler (upper) assembly and the idler (lower)
assembly with the two screws (PWH4 x 8) and hook the
timing belt (X) on the idler assembly.
m
. When the number of extension consoles to be connected
is 3 or 4 : Attach it to the second extension console.
. When the number of extension consoles to be connected
is 5 or 6 : Attach it to the third extension console.
Idler (lower) assembly
PWH4 x 8
PWH4 x 8
Timing
belt (X)
6. Installing the Carrier Assembly
Install the carrier assembly in reverse order of "1-1. Carrier
assembly".
m
. When moving the carrier assembly on the Y rail, move it
to the front (near to the outside cabinet side) so that the
hand block must not be caught by the bin assembly.
. After the carrier assembly is installed, remove the
screwdriver that is used to fix the carrier assembly to the
desired height, from the Y rail.
7. Installing the Outside Cabinet
Attach the outside cabinet parts referring to step 12 of
Section "6-5. Connecting Extension Consoles".
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
Idler (upper) assembly
Timing
belt (X)
PWH4 x 8
PWH4 x 8