Table of Contents
Advertisement
6-3. Removal of the Shipping Metal Fixtures
6-3. Removal of the Shipping Metal
Fixtures
The transfer assembly and the carrier assembly are fixed
inside the console by shipping metal fixtures to avoid
damage during shipment. This section describes how to
remove these metal fixtures.
When the basic console and the extension console are
going to be installed at the same time, perform the follow-
ing "3. Shipping metal fixture of X-axis direction" and "4.
Shipping metal fixture of the Z-axis direction", after the
connection work has been already completed.
n
Be sure to store the removed shipping metal fixtures for
future shipment and maintenance such as parts replace-
ment.
6-6
1. Rear door
Removal
1. Remove the six screws (with drop-safe) in the DMS-
DMS-B150L/B210S
RK4 x 20 (with drop-safe)
Shipping metal
fixture (X)
Shipping metal
fixture (Z)
DMS-B80L/B110S
Shipping metal
fixture (Y)
Shipping metal
fixture (X)
n
Store the removed rear door to prevent scratches or
breakages.
B150L/B210S or three screws in DMS-B80L/B110S
and open the rear door.
n
These screws have drop-safe washers. Do not remove
the screws forcibly.
RK4 x 20 (with drop-safe)
RK4 x 20 (with drop-safe)
RK4 x 20 (with drop-safe)
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
Rear doors
RK4 x 20 (with drop-safe)
Rear door
Advertisement
Table of Contents
