Sony PetaSite DMS-B150L Installation Manual page 47

3. Remove the four hexagonal head cap bolts (M4 x 8)
and move the X stopper (T)/(B) from the basic console
to the same position of the end console (the console
that is connected at the end).
M4 x 8
M4 x 8
4. Remove the four hexagonal head cap bolts (M5 x 12)
and the four washers (D5) from the X sliders (top)/
(bottom) of the transfer assembly. Remove the belt
fixing panel (X).
Belt fixing panel (X)
Washers
(D5)
M5 x 12
M5 x 12
Belt fixing panel (X)
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
M4 x 8
X stopper (T)
X stopper (B)
X slider (top)
Washers (D5)
X slider (bottom)
5. Loosen the hexagonal head cap bolt (c) of the upper X
tension assembly to lighten the load of the spring.
6. Remove the two hexagonal head cap bolts (d) that fix
the upper X tension assembly and remove the X
tension assembly.
7. Loosen the hexagonal head cap bolt (a) fixing the X
belt pulley (top). While holding the X belt pulley (top)
with hands, remove the two hexagonal head cap bolts
(b) and two washers (D4). Remove the X belt pulley
(top).
n
Be careful that the X belt pulley falls when the two
hexagonal head cap bolts (b) are removed. Be sure to
support the X belt pulley with hands during removal.
8. Loosen the hexagonal head cap bolt (c) of the lower X
tension assembly in the same way as step 5.
9. Remove the two hexagonal head cap bolts (d) fixing
the X tension assembly and remove the X tension
assembly.
10. Loosen the hexagonal head cap bolt (a) fixing the X
belt pulley (bottom). Remove the two hexagonal head
cap bolts (b) and two washers (D4). Remove the X
belt pulley (bottom).
(a) M4 x 14
X belt pulley
assembly (top)
(b) M4 x 14
(b) M4 x 14
X belt pulley
assembly (bottom)
(a) M4 x 14
6-5. Connecting Extension Consoles
X tension
assembly
(c) M4 x 25
(d) M4 x 8
Washers (D4)
(b) M4 x 14
(b) M4 x 14
Washers (D4)
(d) M4 x 8
(c) M4 x 25
X tension
assembly
6-21