Sony PetaSite DMS-B150L Installation Manual page 40

6-5. Connecting Extension Consoles
6. Remove the drive stage.
n
Each drive stage is numbered.
Be sure to re-attach the removed drive stages at the
same position while referring to the figure below.
2
1
(1) Loosen the two fixing screws.
(2) Pull out the drive stage until the lock levers on the
right and left of the drive stage are locked.
(3) While pushing the lock levers on the right and left of
the drive stage, pull out the drive stage again and
remove it.
Lock lever
Fixing screw
6-14
Lock lever
(4) Release the locks of the right and left rails in the
direction of the arrows as shown and push in the rails.
Lock levers
Rail
7. Remove the rear door of the extension console.
(1) Loosen the three screws (with drop-safe) and open the
rear door.
n
These screws have drop-safe washers. Be careful not
to remove the screws.
(2) Remove the rear door from the pin at portion B by
raising it slightly while pulling portion A in the
direction of the arrow as shown. Remove then the rear
door from the console.
n
Be careful not to drop the φ 6 poly washer. If it is
dropped, insert it into the pin of portion B as shown in
the figure.
RK4 x 20
(with drop-safe)
Rear door
RK4 x 20
(with drop-safe)
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
Rail
Portion A
φ 6
poly washer
Portion B