Sony PetaSite DMS-B150L Installation Manual page 43

2-2. When connecting the extension consoles in
the range of 3 to 6
1. Connect the extension console to the basic console.
(1) Attach the supplied pillar reference pin and spring
washer to the basic console as shown in the figure.
(2) Align the three reference pins with the reference holes
while adjusting the height of the four casters on the
extension console, and connect the extension console
to the basic console.
(3) If there is a clearance between the contact surfaces of
the basic console and the extension console, adjust the
height of another four casters to remove the clearance.
Basic console
Extension console
Reference
pin
Casters
Casters
Table 1
Basic dimensions
Dimension of A-A (Top)
Dimension of A-A (Bottom)
Difference (Top-Bottom)
Accumulative differences (Top-Bottom)
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
Reference
hole
Pillar reference
pin
SW4
Reference
hole
Reference pin
Allen wrench (10 mm)
M20
N20
Loosen
here.
Caster
B-EX1 EX1-EX2
40 40
2. Fix both consoles with the eight hexagonal head cap
bolts (M4 x 8) supplied with the extension console.
3. Measure the dimensions A-A of the X reference pins
using a caliper. Measure the dimensions of both the
top stage and bottom stage. (Write down the measured
values in the following table.)
4. Open the flat cable clamp of the extension console and
connect the flat cable to the connector (CN102 : SE-
590 board) of the basic console.
Flat cable clamp
M4 x 8
EX2-EX3 EX3-EX4 EX4-EX5
40 40 40
6-5. Connecting Extension Consoles
CN102
X reference
pins A
M4 x 8
X reference pins A
X reference pins A
Caliper
EX5-EX6
40
6-17