Configuring The D100 Using Ip Office Manager - Avaya D100 Installing And Administering

Since static addressing requires DHCP to be off, the base station cannot retrieve the network
parameters from IP Office and you must turn off the DHCP client and configure the base station's
network parameters using the Base Station Web Management Interface.
A base station is configured as a DHCP client by default, so you must access that base station
and configure the addressing parameters, otherwise the base station assigns an address
automatically. When there is no DHCP server in the subnet, the base station uses the following
addressing parameters:
• IP Address: 192.168.1.100
• Mask: 255.255.0.0
Once you know the IP address of the base station, enter this address in a web browser on a PC
connected to the subnet. Doing so provides access to the Base Station Web Management
Interface. For more information, see
Procedure
1. Configure the base station in IP Office Manager according to the instructions in
the D100 using
• Configure the SIP DECT Line as described in
• Configure the SIP DECT Extensions as described in
page 20.
• Mandatory: Configure the static IP parameters for the base station. See
static IP parameters for the base station
2. In the Base Station Web Management Interface, configure the static IP parameters for the
base station. See
Interface
3. Connect the base station to the subnet where the IP Office resides.
The base station downloads the configuration parameters and reboots if any parameters
were modified.
Related links
System configuration

Configuring the D100 using IP Office Manager

Using IP Office Manager, configure the D100 for use on IP Office.
You must configure the D100 components in IP Office prior to connecting and powering the base
station. Otherwise, if the base station is already connected and running, you will have to reboot
the base station after you configure IP Office.
The D100 SIP DECT system consists of two types of components:
• A SIP DECT Line that represents a D100 base station
• A SIP DECT Extension that links a specific user to a D100 base station
Ensure that you associate a SIP DECT Extension with a single SIP DECT Line.
April 2020
Base Station Web Management Interface
on page 17.
Configuring the D100 using the Base Station Web Management
on page 22.
on page 15
Installing and Administering D100 SIP Wireless Phones
Configuring the D100 using IP Office Manager
Configuring the base station
Configuring the extensions
on page 21.
on page 65 .
Configuring
on page 18.
on
Configuring the
17