Avaya D100 Installing And Administering page 57

Reset base station
Reset the D100 base station using the following procedure on the handset. This procedure
restarts the base station but does not reset the device to any factory defaults. To reset the device
to factory defaults, see
Procedure
1. From the Administrator Setting menu, use the Next and Prev keys to navigate to Reset
Base Station and press the Select soft key.
The handset display shows a confirmation message.
2. Press Yes to restart the base station.
Press No to return to the menu list.
Related links
Administrator settings
Check firmware update
Use the following procedure to check for new firmware updates. You must be an administrator to
access the menu.
Procedure
1. From the Administrator Setting menu, use the Next and Prev soft keys to navigate to
Check Firmware Update and press Select.
The base station checks for a firmware update while the handset display reads
Connecting.... After a short amount of time, the handset display shows the latest firmware
version.
2. Press the Update soft key to update the firmware. Press the Back soft key to cancel the
firmware update.
3. Press Yes to confirm the firmware update. Press No to return to the menu list.
If the current firmware and the latest firmware are the same, the update will not occur and
the display will read The Same Version for three seconds prior to returning to the menu
list.
The base station reboots itself after updating the firmware.
Related links
Administrator settings
Error information
You can access error information from the Administrator Setting menu. For more information about
error messages, see
April 2020
Factory settings on page 72.
on page 53
on page 53
Handset display reads "No Service"
Installing and Administering D100 SIP Wireless Phones
on page 78.
Overview
57