Avaya D100 Installing And Administering page 54

Administration and maintenance
many of the following procedures begin with the Administrator Setting menu, do not misplace
the administrator password.
By default, this password is 7 8 2 8 8 7 6. To change the password, see
change on page 55.
Note:
The moment you enter the Administrator Setting menu on a handset, the system refuses
entry to all other handsets connected to that base station. Any attempt to enter the menu on
another device results in the message Denied.
Procedure
1. In the configuration menu, navigate to Administrator Setting and press the Select soft
key.
2. Enter the administrator password, and press the OK soft key. Press the Del soft key to
delete the last character entered.
By default, the administrator password is 7 8 2 8 8 7 6 (or 'Q U A T T R O').
3. If the password is correct, navigate to the desired menu.
If the password is incorrect, the display reads Failed and the handset emits an error tone
before returning to the main menu.
Related links
Administration on the handset
DECT PIN change
Administrator password change
Diagnostics on page 55
Reset base station
Check firmware update
Error information
DECT PIN change
You can change the DECT PIN using the following procedure. If the system has more than one
base station, you should assign each base station a unique DECT PIN to prevent registration to
an unintended base station.
Note:
Only the administrator can change the DECT PIN, using the administrator password and the
new 4-digit DECT PIN.
Procedure
1. From the Administrator Setting menu, use the Next and Prev keys to navigate to DECT
PIN Change and press the Select soft key.
2. Enter the new 4-digit DECT PIN, or press the Deflt soft key.
April 2020
on page 53
on page 54
on page 55
on page 57
on page 57
on page 57
Installing and Administering D100 SIP Wireless Phones
Administrator password
54