Configuring The D100 Using Ip Office Manager - Avaya D100 Installation And Administration Manual

A base station is configured as a DHCP client by default, so you must access that base station
and configure the addressing parameters, otherwise the base station assigns an address
automatically. When there is no DHCP server in the subnet, the base station uses the following
addressing parameters:
• IP Address: 192.168.1.100
• Mask: 255.255.0.0
Once you know the IP address of the base station, enter this address in a web browser on a
PC connected to the subnet. Doing so provides access to the Base Station Web Management
Interface. For more information, see
page 71 .
Procedure
1. Configure the base station in IP Office Manager according to the instructions in
2. In the Base Station Web Management Interface, configure the static IP parameters
3. Connect the base station to the subnet where the IP Office resides.

Configuring the D100 using IP Office Manager

Using IP Office Manager, configure the D100 for use on IP Office.
You must configure the D100 components in IP Office prior to connecting and powering the
base station. Otherwise, if the base station is already connected and running, you will have to
reboot the base station after you configure IP Office.
The D100 SIP DECT system consists of two types of components:
• A SIP DECT Line that represents a D100 base station
• A SIP DECT Extension that links a specific user to a D100 base station
D100 SIP Wireless Terminal Installation and Administration Guide
Configuring the D100 using IP Office Manager
• Configure the SIP DECT Line as described in
page 22.
• Configure the SIP DECT Extensions as described in
extensions on page 23.
• Mandatory: Configure the static IP parameters for the base station. See
Configuring the static IP parameters for the base station
for the base station. See
Management Interface
The base station downloads the configuration parameters and reboots if any
parameters were modified.
Configuring the D100 using IP Office Manager
Base Station Web Management Interface
Configuring the D100 using the Base Station Web
on page 26.
on
on page 21.
Configuring the base station
Configuring the
on page 25.
December 2012
on
21