Avaya D100 Installing And Administering page 30

Hardware preparation and installation
2. Depending on your place of residence:
• Press soft key #1 to start the measurement for a North American site.
• Press soft key #2 to start the measurement for a European site.
The measurement occurs quickly and then the handset display shows the results. The top
line of the display shows the number of clear slots, and the second line of the display
shows the number of clear channels and the associated slots. For example:
NA Clear Slot: 12 / 12
544333444555 49 / 60
This example indicates the following:
• The survey has completed on a North American site.
• All 12 slots had at least one free channel.
• All five channels were free on slots 1, 10, 11, and 12.
• Four channels were free on slots 2, 3, 7, 8, and 9
• Three channels were free on slots 4, 5, and 6.
Note:
The site should have at least 10 clear slots in order for the D100 to work properly.
3. Press the soft key used in step 2 to restart the survey. In North America, you can press soft
key 3 to continue with a base station survey. See
page 30.
Press the On-Hook key to return the handset to normal operating mode.
Related links
Site planning on page 25
Performing a base station survey
Use the following procedure to confirm that the DECT RF spectrum is not fully occupied by other
DECT base stations in the area.
Note:
The D100 only supports survey mode on North American band frequency.
Procedure
1. Press and hold the * and # keys and insert the battery into the handset at the same time.
2. Press soft key #3.
The handset begins to count, or "rake", the available RFPI and lists the results on the
display.
3. When complete, the handset reads Stop Raking RFPI followed by the number of RFPIs
detected.
April 2020 Installing and Administering D100 SIP Wireless Phones
Performing a base station survey on
30