Avaya D100 Installing And Administering page 39

Procedure
1. While the handset is in an Unregistered or Searching state, press the Regist soft key.
The handset display flashes a message that reads Press Reg. Key On Base.
• If the handset is in a Searching state, the handset is attempting to find a new base
station. Press the Regist soft key followed by the OK soft key to continue with the
registration procedure.
2. Press and hold the Registration key on the front of the base station for approximately
three seconds until the LED blinks.
• Alternatively, you can use System Status Application to enable Registration mode on the
handset. See
The base station automatically exits registration mode when no handset or repeater
registrations have been performed for over two minutes.
3. After the handset finds the base station, you must enter the four-digit DECT PIN code and
press OK. If the base station uses the default DECT PIN code, you can press the Deflt soft
key.
The Cancel or On-Hook soft keys cancel the registration process.
Note:
You have 30 seconds to enter the four-digit DECT PIN code before the handset returns
to Unregistered mode. For more information, see
After registration is complete, the handset enters a logged-out state, ready for a user to log
in.
Related links
Handset registration
De-registering a handset using the handset
You can perform de-registration on the handset using the following procedure. Note that de-
registration does not affect calls in progress.
Procedure
1. From either the Idle or logged-out state on the handset, press the Config soft key.
The display reads Configuration... while the handset attempts to connect to the base
station.
Press the On-Hook key to quit de-registration at any time.
2. After connecting to the base station, the handset display provides a menu list that you can
navigate using the Next and Prev soft keys. Navigate to Administrator Setting and press
the Select soft key.
3. Enter the administrator password and press OK.
April 2020
SystemStatusApplication
on page 38
Installing and Administering D100 SIP Wireless Phones
on page 49.
Administrator settings
Overview
on page 53.
39