Base Station Installation - Avaya D100 Installing And Administering

Sip wireless phones ip office

Hide thumbs Also See for D100:

Table of Contents

Note:

In order for the D100 to work reliably, the number of RFPIs detected in the site should

be less than or equal to 40.

4. Press soft key #3 to restart the process.

Press the On-Hook key to return the handset to normal operating mode.

Base station installation

Install the base station in a location that provides the least amount of interference. See

planning

on page 25. Before you install a base station, you must understand the usage scenarios

so that you can determine whether or not the environment is acceptable. Bear in mind the

following:

• Signal direction: The signal from a base station does not propagate evenly in all directions.

The signal typically propagates strongest in the horizontal plane. However, the base station

might be able to serve callers on other floors. You can then provide coverage to areas not

frequently used and so not meriting a dedicated local base station.

• Other radio signals: Receiving normal broadcast radio signals in an area is not an indication

that the base station will receive DECT signaling.

You can install the base station simply by plugging in the required connectors but you must first

determine the coverage area. Prior to installing the device, you can deploy various surveys to

detect the number of available channels in the environment as well as any pre-installed base

stations. See

Performing a DECT site survey

page 30.

Table of Contents

D160