Updating Handset Firmware - Avaya D100 Installing And Administering

Administration and maintenance
Related links
Overview on page 49

Updating handset firmware

To update the D160 handset firmware, you must install Microsoft .NET version 4 and you must use
the D160 Upgrade Jig.
To check your version of Microsoft .NET, click Control Panel > Add or Remove Programs. If you
do not have Microsoft .NET version 4, download it directly from Microsoft at:
http://www.microsoft.com/en-us/download/search.aspx?q=.net%204.0%20
If you update the handset firmware on a live system, you must reboot the base station to which the
handset registers once the update completes.
Before you begin
Ensure that the handset battery has enough power to last the duration of the upgrade, which might
be a few minutes. Also, ensure that you have the latest USB-UART driver installed for the
Upgrade Jig (CDM 2.04.06 WHQL Certified), which is also required. Locate the available Upgrade
Jig drivers for each operating system in the Upgrade Jig Drivers folder.
Procedure
1. Connect the Upgrade Jig to the PC through an available USB port.
2. Extract the D160 Firmware Upgrade file to anywhere on your PC.
3. In the extracted folder, run the D160 Handset Writer application.
The D160 Handset Writer window appears:
April 2020 Installing and Administering D100 SIP Wireless Phones 70