Resetting The Base Station Using The Base Station Web Management Interface; Resetting The Base Station Using The Base Station - Avaya D100 Installing And Administering

Factory settings
Resetting the base station using the Base Station Web
Management Interface
Using the Base Station Web Management Interface to reset the base station to factory default is
an alternative method that you should only attempt when System Status Application fails, or if the
base station does not appear in System Status Application at all.
For more information, refer to
If this alternative method also fails, only then should you attempt the ulterior method described in

Resetting the base station using the base station

Procedure
1. In the Base Station Web Management Interface, navigate to the Setting Menu in the left
navigational pane.
2. Select Reboot Base Station.
3. Select Execute (Factory Initialize).
The base station resets to factory default.
Related links
Resetting the base station to factory default
Resetting the base station using the base station
Only use this method to reset the base station to factory default when the preferred and alternative
methods fail. See
method.
Procedure
1. Press and hold the Registration button located on the front of the base station and insert
a pin into the Reset button hole also located on the front of the base station. Hold both
buttons for five seconds.
The base station resets the following parameters to the default values indicated:
• IP Address: 192.168.1.100
• Subnet Mask: 255.255.0
• Default Gateway: 192.168.1.1
2. You can now use the Base Station Web Management Interface to reset the base station.
See

Resetting the base station using the Base Station Web Management Interface

page 74.
April 2020
Base Station Web Management Interface
Resetting the base station using
Installing and Administering D100 SIP Wireless Phones
on page 74.
on page 73
on page 73 before you attempt the following
on page 65.
on
74