Avaya D100 Installing And Administering page 37

Next steps
After installing and connecting the base station to IP Office, register the handsets and install the
appropriate repeaters for that base station.
Related links
Base station installation
Powering the base station
The base station receives power through the Ethernet cable using Power over Ethernet (PoE).
Ensure that you plug the provided cable into a PoE-enabled switch that connects to the network
where IP Office resides. Alternatively, you can use a PoE Power supply with a non-PoE Ethernet
interface.
Connect the Ethernet cable to the input on the back of the base station. The power LED should
turn on.
Related links
Base station installation
Booting up
The following sections identify the boot up sequence and the IP address decision schemes that
you require to install the D100 successfully. For information about LED behavior, which can be of
assistance when determining the device state, see
Before you begin, ensure that you configure IP Office according to the appropriate deployment
scenario. For more information, see
Related links
Base station installation
Boot up sequence
Boot up sequence
Use the following procedure to boot up the base station.
Before you begin
Ensure that you have the required components:
• D100 base station
• D160 handset
• Ethernet cable for PoE
Procedure
1. If DHCP is enabled, the base station obtains the IP address from the DHCP server.
If DHCP is disabled, the base station begins to boot up with the IP address that was
provided in advance. The status LED flashes to indicate the booting status.
2. If the current IP parameters of the base station differ from those parameters received from
IP Office, the base station loads the new parameters and reboots.
April 2020
on page 31
on page 31
System configuration
on page 31
on page 37
Installing and Administering D100 SIP Wireless Phones
Display properties on page 12.
on page 15.
Overview
37