Avaya D100 Installing And Administering page 16

System configuration
When adding a new SIP DECT Line, IP Office Manager assumes that the base station acts as the
DHCP client. In some deployments, configuring the base station's IP parameters statically might
be desirable.
A single IP Office can support up to four base stations. If multiple base stations are connected to
an IP Office, you must configure the MAC Address parameter for each of the SIP DECT Lines
using IP Office Manager. If only one base station is connected to the IP Office, you do not need to
configure the MAC Address.
Consider the following network configuration scenarios before you deploy the D100 terminal.
Network configuration
A single IP Office in the subnet that hosts the DHCP server.
A single IP Office in the subnet with DHCP hosted by a third-
party server.
Multiple IP Office units with the DHCP located on an IP Office
unit where the base station is configured.
All other network configuration scenarios require static IP
addressing.
Scenario 1
You must configure the base station in IP Office Manager.
In this scenario, you can still configure the base station with static IP parameters. If you configure
static IP parameters, the base station uses and maintains these parameters after rebooting the
base station, or until you modify the IP parameters in IP Office Manager.
Procedure
1. Configure the base station in IP Office Manager:
• Configure the SIP DECT Line as described in
• Configure the SIP DECT Extensions as described in
page 20.
• Optional: Configure the static IP parameters for the base station. See
static IP parameters for the base station
Double-check the values you enter as you might inadvertently lose connectivity to the base
station by providing incorrect values.
2. Connect the base station to the subnet where the IP Office can be reached.
The base station downloads the configuration parameters and reboots if any parameters
were modified.
Scenario 2
You must use static IP addressing for the base station.
In static addressing, you must configure each base station individually in IP Office Manager with
network-specific addressing. In addition, you must configure static IP addressing on the base
station prior to installing it on the network.
April 2020 Installing and Administering D100 SIP Wireless Phones
Scenario reference
Follow Scenario 1
Follow Scenario 1
Follow Scenario 1
Follow Scenario 2
Configuring the base station
Configuring the extensions
on page 21.
on page 18.
on
Configuring the
16