Chapter 4: Hardware Preparation And Installation; Overview - Avaya D100 Installing And Administering

Sip wireless phones ip office

Hide thumbs Also See for D100:

Table of Contents

Chapter 4: Hardware preparation and

The following sections contain all the relevant information pertaining to installing the base station,

determining the installation scenarios, powering and booting the base station, discovering IP

Office, and more.

The first step toward successfully installing a base station is to consider the installation scenarios.

Once you determine the scenario that best suits your environment, plan the site for deployment

using a floor plan.

You can perform site surveys in the environment to assist you with the site and floor planning.

Using the handset, you can perform a DECT site survey to determine the number of slots

available in the 12–slot DECT frame. You can also perform a base station survey to count the

number of base stations that exist within range of the handset performing the survey.

After you plan the site, register the handsets to the correct base station as identified by your floor

plan. When registering repeaters, first determine the appropriate installation scenario. You should

base station. After you determine either long and narrow coverage or broad coverage, and prior to

mounting any repeaters, you can use a signal strength survey to test the desired location. If you

determine that the location receives an adequate signal from the base station, test and mount the

repeater.

Danger:

Never install electrical cords across traffic areas where they cause a trip hazard. If the cords

are damaged, they can create fire or electrical hazards.

Table of Contents

D160