Information Display; P10, P20, And P30 Consoles - Precor Experience 700 line Series Service Manual

MAINTENANCE
MENU
» AS light Brightness
(1)
» Maintenance
Reminder
Notes: (1) Only used on machines that support the Active Status Light feature.

Information Display (65)

Service Access Code: 6,5 (see
The Information Display is only supported on P10, P20, and P30 consoles. On P62, P80, and
P82 consoles, refer to Club Settings for similar information.
The Information Display menu provides information about the machine usage, software, main-
tenance, and the error event code log.

P10, P20, and P30 consoles

METRIC
ODOMETER
HOUR METER
(2)
BELT RATING
Yellow Solid: Indicates an error has occurred, was self-corrected
and the machine can be used. The fault can be cleared.
Yellow Pulsing There is a current non-recoverable fault con-
dition, there is a loss of a major function and the machine id out-
of-service. Machine service is required.
menu: Maintenance > Active Status Light > AS Light Bright-
ness
Range: low, medium, bright
Adjust the ASL brightness level.
menu: Maintenance > Active Status Light > Maintenance
Reminder
Range: OFF/ ON (default)
Switch the maintenance reminder function ON or OFF.
"Service Access Codes" on
The total number of accumulated miles on the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
The total number of hours that the unit took to accumulate
unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
Displays the belt rating from 10 (best) to 0 (worst). Reset-
table to 10 by holding down QuickStart.
3 Standard Service and Diagnostics Software
DESCRIPTION
page 18)
DESCRIPTION
Information Display (65)
Page 35