Power Cord Replacement; About; Procedure - Precor Experience 700 line Series Service Manual
Base, 120 vac and 240 vac
Hide thumbs
Also See for Experience 700 line Series:
- Service manual (246 pages) ,
- Assembly manual (12 pages)
Table of Contents
Advertisement
Power Cord Replacement
About
This procedure provides instruction to replace the power cord.
ID
Power Entry Assembly
Power Cord
ON/OFF SW Circuit Breaker
Procedure
Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and
TIP: For easier access, raise the incline to maximum before removing input power.
Access the service Hardware Validation (51765761) and use the
CROSSRAMP/INCLINE Test to raise the incline and then remove power.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Description
1
unplug
the power cord.
5 Replacement Procedures
Power Cord Replacement
Page 77
Advertisement
Table of Contents
Troubleshooting
