Input Power Requirements - Precor Experience 700 line Series Service Manual

solution.
General:
l
1 oz. mild soap (Simple Green) to 30 oz. water.
o
Athletix equipment cleaner, 9x7 pre-saturated wipes
o
Enivir Safe oxygen enhanced cleaner or Envir Safe glass and multitask cleaner
o
concentrate.
Console and PVS: a diluted solution of one part 91% Isopropyl alcohol to one part
l
water.
CAUTION: Do not use acidic cleaners and do not spray directly onto the equipment
surfaces.

Input Power Requirements

The following information provides the treadmill and console power, RF, and Ethernet require-
ments to correctly and safely power and use the treadmill.
US and Canada power requirements
Precor treadmills must be connected to a 20 amp, individual branch circuit that can be shared
only with one PVS (Personal Viewing System) display. If you need additional help with the
power connections contact your Precor authorized dealer.
Individual branch circuit: An individual branch circuit provides a hot conductor and neutral
conductor to a receptacle. The conductors must not be looped, "daisy-chained", or connected
to any other conductors or receptacles. The circuit must be grounded according to NEC
guidelines or local region electric codes.
CAUTION: NEC (National Electric Code) guidelines or local region electric codes
must be complied with.
Input Power
Nominal 120 VAC models
Operating voltage: 90 VAC to 132 VAC.
l
Frequency: 47 - 65 Hz
l
Nominal 240 AC Models
Rated Operating voltage: 180 VAC - 264 VAC.
l
NOTE: An Internal operating voltage range of 180 – 275 VAC with reduced per-
formance is allowed.
Frequency: 47- 65 Hz
l
Frame Ground
1 Introduction
General Information
(ATHLETIX PRODUCTS).
Page 10