Perform Hardware Validation Diagnostic Tests; Verify Club Settings; Verify That There Are No New Error Codes; Verify Service Bulletins - Precor Experience 700 line Series Service Manual

Perform hardware validation diagnostic tests

Access the Hardware Validation Diagnostic Tests service mode and run any related tests that
might help isolate the cause of the issue, see
(51765761)" on page 23. These tests will help identify good and failed components. Resolve
any resulting failures.

Verify Club settings

Verify that one of the Club Settings (see
parameter limits are not causing the issue. If a failure is observed while using the machine but
passes the hardware validation diagnostic tests, this could be an indication that one of the club
parameters limits settings is causing the issue.

Verify that there are no new error codes

After correcting the issue, reopen the Error Log and verify that there are no remaining active
error codes. This will verify that the original error codes are not reoccurring and that there are
no new error code issues. If the error code is reoccurring, the issue may be mileage related,
review the error code odometer history to verify if the error event is related to mileage inter-
vals.
On P10, P20, and P30 consoles, clear the error log by pressing and holding the "Quick Start"
key.
Note: If there is no logged error codes and the issue persists, you will need to use
observable and audible indicators to identify the source of the failure. Also make
sure that there are no related service bulletins that may resolve the issue. Browse
the list of available Troubleshooting procedures for related Troubleshooting inform-
ation.

Verify service bulletins

Review the list of machine service bulletins and tech-tips and verify that there are no current
bulletins that may fix the issue.
"Hardware Validation Service Menu
"Club Settings Service Menu (5651565)" on
6 Troubleshooting
Basic Steps
page 26)
Page 154