2. Remove the hood cover, see
3. Remove the four #3 Phillips fasteners and remove the Power Entry Assembly bracket
. Hold the bracket while removing to prevent wire cable damage. Retain fastener
hardware for installation.
4. Disconnect the ASL interface cable RJ11 connector, see
5. Remove the ASL PCA Bracket
tom (underside) of the Power Entry Assembly Bracket
6. Unsnap the ASL PCA
tab clip to remove.
Installation Instructions
"Hood Cover Replacement" on
by pressing the inner and outer tab clips on the bot-
board from the ASL PCA Bracket
5 Replacement Procedures
ASL PCA Replacement
page 60.
"Wire Diagram" on
page 83.
while lifting the ASL bracket.
by pressing the outer
Page 86